Telcoma Automations T21 Manual De Instrucciones página 42

GB
COUPLING TYPE RECEIVER model OC (optional)
The receivers are "self-learn" type and can memorise several codes on the same channel.
The functions of the two radio channels are:
Channel 1 Step/Step
Channel 2 Pedestrian
To memorise the transmitters proceed as follows:
- Insert the receiver in the connector (detail 7 of fig. 1)
- Power up the control unit and wait for the receiver leds to turn off.
- On the receiver, briefly press the push button of the channel to be memorised, (P1 step/step or P2 pedestrian) and
the corresponding led starts to flash. If the led emits double flashes, wait briefly and repeat the operation (the push
button must only be pressed once).
- Transmitter with remote control to be programmed.
- If the led on the receiver emits a longer flash, this means that memorisation is successful.
- If the code is already present in the memory, the receiver leds all flash simultaneously.
The code memory can be reset if required, by pressing and holding P1 on the receiver for approx.15 seconds until all
leds light up.
The aerial must be connected to terminals 8 (sheath) and 9 (control unit), see fig. 2.
For further information and specifications, see the manual supplied with the receiver.
FINAL TESTING
A final test should always be made after completing all programming procedures.
- Check correct operation of the protection devices (anti-crushing system, stop button, photocells, sensitive edges
etc.)
- Check correct operation of the signalling devices (flashing lights, gate open indicator etc.).
- Check correct operation of the control devices (S/S push button, radio controls etc.).
42