Ce Declaration Of Conformity - Telcoma Automations T124 Manual De Instrucciones

GB
IMPORTANT RECOMMENDATIONS CONCERNING INSTALLATION
Only qualified personnel having the legal requirements must install the automation according to the principles of good
workmanship and in conformity with the machinery directive 98/37/CE and standards EN 12453 and EN 12445.
Check that the existing structures (posts, hinges, leaves) are stable in relation to the forces developed by the motor.
Check that suitably robust limit stops have been installed for end of gate opening and closing.
Check the state of the cables that are already present in the system.
Analyse the hazards connected with the automation system and adopt the necessary safety and signalling devices
accordingly.
Install the commands (e.g. the key selector) so that the user is not placed in a hazardous area when using them.
Upon completion of the installation, test the safety, signalling and release devices of the automation system several times.
Apply the CE label or plate with information regarding the hazards and identification data on the automation.
Give the end user the instructions for use, the safety recommendations and the CE declaration of conformity.
Ensure that the user has understood the correct automatic, manual and emergency operation of the automation system.
Inform the user in writing (e.g. in the instructions for use) of any unprotected residual risks and of foreseeable misuse.
Inform the user in writing (in the use instructions for example):
Of possible non secluded residual risks and of foreseeable improper use.
To disconnect the power supply when cleaning the area that is automated or when performing small maintenance
operations (e.g.: repainting).
To frequently control that no visible damage has occurred to the automation, and to inform the installer immediately if
damage is noticed.
Not to allow children to play in the vicinity of the automation.
Prepare a maintenance schedule for the automation installation (at least once every 6 months for the safety devices),
recording the work carried out in a special book.
In line with its continual product improvement policy, whether aesthetic or functional, TELCOMA S.r.l. reserves the right to alter
specifications without notice.
DISPOSAL
This product is made up of various components that could contain pollutants. Dispose of properly!
Make enquiries concerning the recycling or disposal of the product, complying with the local laws in
force.

CE DECLARATION OF CONFORMITY

The undersigned Ennio Ambroso
TELCOMA S.r.l. Via Luigi Manzoni 11, 31015 Conegliano (TV) ITALY
declares that the product:
Model T124 for use as: Gate automation control unit
Model: CB124 for use as: Battery charger
complies with the essential requirements of section 3 and relative measures of Directive 1999/5/CE, if used for
the purpose for which it has been designed.
complies with the essential requirements of Directive 89/336 (EMC), EN 61000-6-3, EN 61000-6-1 and
subsequent amendments, if used for the purpose for which it has been designed.
complies with the essential requirements of Directive 73/23 (LVD), EN 60335-1 and subsequent amendments, if
used for the purpose for which it has been designed.
Place and date: Conegliano, 01/10/2010
, Legal representative of the company:
Legal representative
Ennio Ambroso
43