Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Installation instructions (continued)
A: Usage Situations
where Appliance
Power Cord
will be Disconnected
Infrequently.
An adapter
may be used only on a 15-amp circuit
Do
not use an adapter
on a 20-amp
circuit. Where
local
codes
permit,
a TEMPORARY
CONNECTION
may
be made
to a properly
grounded
two-prong
wall
receptacle
by the use of a UL-listed
adapter, available
at most hardware
stores, The larger slot in the adapter
must be aligned
with the larger slot in the wall recep-
tacle to provide
proper polarity in the connection
of the
power cord°
TEMPORARY
METHOD
(Adapter plugs not permit-
[__'-_-_.
ted in Canada)
-.-_
_
:I_!_,} t !
Arigo t arge p rongs/slots
!l
[_
firm connection before use
CAUTION:
Attaching
the adapter
ground terminal
to the walt receptacle
cover screw does not ground
the appliance
unless the cover screw is metal, and
not insulated,
and the wall receptacle
is grounded
through
the house
wiring,
The customer
should
have the circuit checked
by a qualified
electrician
to make sure the receptacle
is properly
grounded,
When disconnecting
the power cord from the adapter,
always
hold the adapter
with one hand.
tf this is not
done,
the adapter
ground
terminal
is very likely to
break
with repeated
use. Should
this happen,
DO
NOT
USE the appliance
until a proper
ground
has
again been established.
B: Usage Situations
where Appliance
Power Cord
will be Disconnected
Frequently,
Do
not
use
an adapter
plug
in these
situations
because
disconnecting
of the
power
cord
places
undue strain on the adapter
and leads to eventual fail-
ure of the adapter
ground
terminal.
The customer
should
have the two-prong
wall receptacle
replaced
with a three-prong
(grounding)
receptacle
by a quali-
fied electrician
before using the appliance.
The
installation
of appliances
designed
for mobile
home installation
must conform
with the Manufactured
Home
Construction
and Safety
Standard,
Title 24
CFR,
Part 3280 (formerly
the Federal
Standard
for
Mobile Home Construction
and Safety, Title 24, HUD,
Part 280) or, when such standard
is not applicable,
the Standard
for Manufactured
Home Installations,
lat-
est edition
(Manufactured
Home Sites,
Communities
and Set-Ups),
ANSI
A225.1,
latest
edition,
or with
local codes. In Canada,
mobile home installation
must
be in accordance
with the current CAN/CSA
Z240/Mtl
Mobile
Home Installation
Code.
Electric Disconnect
1. Locate disconnect
plug on the range back.
2. Pinch sides of connector
and pull out of range back.
You will have this disconnect
plug:
38
Tabla de contenido
