Data Transmit Modulation Delay Time; Ptt Id - Kenwood TK-3230DX Manual De Instrucciones

Data Transmit Modulation Delay Time

This function normally operates fi ne using the default setting,
so it is not necessary to adjust the value. However, there are
certain operating environments that will not allow the use of
FleetSync (Selcall) functions, such as Scan mode. When you
encounter such an environment, readjust the delay time to a
longer time by following the procedures.
To set up a data transmit modulation delay time:
1 Enter the Setting Mode {page 24}.
2 Press the
3 Press the MENU key then press
to select "
" " (1000 ms), "
" (2000 ms).

PTT ID

The transceiver can send a PTT ID signal when pressing the
PTT switch (beginning of transmission) or when pressing and
releasing (beginning of transmission and end of transmission)
the PTT switch.
1 Enter the Setting Mode {page 24}.
2 Press the
3 Press the MENU key then press
to select "
(send your own PTT ID at the beginning of
transmission), or "
selected list ID number PTT ID at the
beginning and end of transmission).
Note:
◆ Transceiver's individual ID number is not available for selection as
PTT ID.
38
or key to select "
" (0 ms), "
" (1500 ms), or "
or key to select "
" (PTT ID is off), "
" to "
".
or
" (500 ms),
".
or
"
" (send