Electrical Connection (Qualified Specialist) - Speck pumpen BADUJET Vogue Instrucciones Para El Manejo

5.4

Electrical connection (Qualified specialist)

WARNING
Risk of electric shock due to incorrect connections!
 Electrical connections must always be carried out by
authorised specialists.
 Observe VDE and utility company regulations.
 Install pumps for swimming pools and their protection
according to DIN VDE 0100-702.
 Install a disconnecting device with at least a 3 mm contact
gap per pole to interrupt the power supply.
WARNING
Risk of electric shock due to voltage on the housing!
 A built-in or external overload switch which is set correctly
must be installed for pumps with three-phase or A.C. motors
without motor protection. In doing so, observe the values on
the motor name plate.
 Protect power supply with a ground fault circuit interrupter,
nominal residual current I
 Only use suitable pipe types according to regional
regulations.
 Adjust minimum diameter of the electrical pipes to
accommodate the motor output and pipe length.
 Do not bend or squash the pipes.
If hazardous situations can occur, provide an emergency off

switch according to DIN EN 809. The builder/operator must
make a decision according to this standard.
03|2020
≤ 30 mA.
FN
Installation
EN 35