Side Brush; Working Adjustments; Flow Adjustment Of The Detergent Solution; Adjustment Of The Brushes Pressure - Tornado BR 40/66 Manual Del Usuario

SIDE BRUSH

The machine is equipped with a side brush
that permits it to clean near the right side
borders.
The function is activated by acting upon
the switch (13) both in manual and in auto-
matic mode. The signal lamp (25) indicates
that the side brush is active and in the
working position.

WORKING ADJUSTMENTS

In both automatic and manual mode, dur-
ing the first feet/metres check:
1. that the adjustment of the detergent
solution flow is sufficient to wet the floor
uniformly avoiding leakage of detergent
from the splash guards (see
under paragraph "FLOW ADJUSTMENT
OF THE DETERGENT SOLUTION").
2. that the squeegee adjustment guar-
antees a perfect drying result (see under
paragraph "ADJUSTMENT OF THE
SQUEEGEE").
3. that the brushes pressure permits an
efficient washing action as it relates to the
dirt and the speed (see under paragraph
"ADJUSTMENT OF THE BRUSHES
PRESSURE").
FLOW ADJUSTMENT OF THE DETER-
GENT SOLUTION
To adjust the detergent solution quantity
that flows down onto the brushes it is nec-
essary to act upon the solution valve knob
(10) placed on the upper part of the side
instrument board, rotating counterclock-
wise to increase it and clockwise to reduce
it up to closure of the flow.
The side brush has an independent water
flow adjustment, with a solution valve (11)
placed under the frame near the brush
itself.
Please remember that the side brush does
not have a scrubbing function but simply
moves the dirt towards the center of the
machine.
16
ADJUSTMENT OF THE BRUSHES
PRESSURE
Both in automatic and in manual mode it is
possible through the selector (4) to adjust
the brushes pressure on the floor in eight
established levels. During the operation,
youcan visualize on the display (1) the
value of the brushes motor by pressing the
button (3).
ATTENTION:
In order not to overload the brushes motor,
it is convenient to reduce the brushes pres-
sure going from smooth floors to rough
ones (ex. concrete).
The presence on the display (1) of a
blinking warning from P2 to P8 indicates
that the pressure level set determines an
overload of the brushes motor. It is
therefore necessary to reduce the pressure
to the level where the blinking warning
stops

ELECTRIC PROTECTION

The machine is equipped with an electron-
ic system of protection for all components
that carry out functions of power or control.
This device blocks the defective compo-
nent and indicates on the display (1)
the corresponding alarm from "AL01" to
"AL20". The last two figures indicate the
number of the alarm code.
ATTENTION:
To restore the functioning of the compo-
nent, turn the machine off and on again us-
ing the key switch. If the problem persists,
please contact the authorized technical
assistance