Honda EU30is Manual Del Propietário página 40

6. Switch on the equipment to be used.
The Output indicator (green) will light.
In case of normal operation
OUTPUT INDICATOR
(GREEN)
• In case of overload operation (refer to page 32) or when trouble occurs for the
equipment being used, the Output indicator (green) will go out, the Overload
indicator (red) will light continuously, and no power will be put out.
At this time, the engine will not stop, so that the engine must be stopped by
setting the respective engine switch to OFF.
NOTE:
• The Overload indicator (red) also lights in the following cases:
When the inverter is overheated; the current to the connected appliance will
be shut off. Check to see if the air intake is obstructed.
• When equipment requiring a large starting power, like a motor etc., is used,
the Overload indicator (red) and the Output indicator (green) may light
together for a short time (about 4 sec), but this is no abnormality. After start of
the equipment, the Overload indicator (red) will go out and the Output
indicator (green) will stay lit.
• When the operation of one generator is to be stopped after start of the
equipment, the special cable/receptacle for parallel operation also must be
removed at the same time.
7. When electric power is to be taken again from the generator, switch off the
equipment to be used and remove the plug from the AC receptacle. Confirm
that the equipment and the connection are normal and that not too much
power is to be taken, and then start the engine.
In case of overload operation or short-circuit
OVERLOAD INDICATOR
(RED)
37