Fit The Receiver Collar - Petsafe BDT-433 Manual De Adiestramiento Y Funcionamiento

To Turn the Receiver Collar On:
1. Press and hold the On/Off Button until the Receiver Indicator Light comes on and
the Receiver Collar beeps 5 times.
2. Release the On/Off Button.
Once the Receiver Collar has been turned on, press the Side Button of the Remote
Transmitter. The Receiver Collar should beep for as long as the Side Button is pressed.
If it does not, see the "Reset the Receiver Collar" section.
To Turn the Receiver Collar Off:
1. Press and hold the On/Off Button until the Receiver Indicator Light comes on and
the Receiver Collar beeps 2 times.
2. Release the On/Off Button.
Important: If the Receiver Collar is left on continuously, the maximum battery
life (before replacing batteries) will be two weeks.
_____________________________________________________________

Fit the Receiver Collar

Step
for effective training. The Contact Points must have direct contact with your
pet's skin on the underside of his neck.
1. Have your pet standing comfortably (3A).
2. Centre the Contact Points underneath your pet's neck, touching
the skin (3B). If your pet has a long or thick coat, use the enclosed
long Contact Points to reach through the hair.
between the collar and your pet's neck (3C).
4. Allow your pet to wear the collar for several
again as your pet becomes more comfortable
with the Receiver Collar. If your pet's neck is
less than 300 mm around, you will need to
thread the part of the collar which includes
the antenna through the buckle. It will be a
t.
5. Trim the collar as follows (3D):
a. Mark the desired length of the collar with a
pen. Allow for growth if your pet is young
or grows a thick winter coat.
ash once every 4 to 5 seconds if the batteries are low.
t and placement of your Receiver Collar is important
t, please follow these steps:
t snugly, yet
www.petsafe.net
t
t
7