ESAB Origo Feed 354 P3 Manual De Instrucciones página 28

contact with another part of an earth-connected object. The electric arc which results from this contact can
hurt the eyes if not protected and cause a fire. The body contact of a part with another conductor without
isolation can cause a violent electric hazard, burns and even death.
N.B.: Cleaning and preventive maintenance should be intensified when
operating in environment contaminated by dust, soot or any other poluent which
can cause damage or harm to the performance.
ATTENTION:
In case of doubts about the operation or maintenance of this or any other ESAB product brand and
manufacturing, contact the department of Technical Service or an authorized ESAB Service.
7.2) Repair
In order to ensure the perfect functioning and performance of a ESAB equipment, use only original parts
supplied by ESAB PLC or approved by them. All guarantee undertakings from the supplier cease to apply if
the customer uses non-original or non -approved parts when replacing any of them.
Spare parts can be obtained from the ESAB Authorized Services or from its Sales Distributors listed on the
last page of this Manual. Always inform the Equipment Model and Serial Number.
8) WIRE MECHANISM
Note: Before ordering spare parts check the serial number of the equipment.
Mechanism A.
0901820
COMPLETE MECHANISM
FEED ROLLER - SEE TABLE 5.1
(*) These parts are subject to wear in normal operation conditions, and should be substituted whenever they
present any wear which interferes with the correct feeding of the welding wire.
28
Origo Feed 354 P3
0706972
GANTY
0706963
SIDE GEAR
PIN (*)
0706914
INTERMEDIATE NOZZLE
0706909
SIDE GEAR PIN
0706910
SHAFT FEED ROLLER
0706911
GEAR (*)
0706917
SPRING
0706916
0706915
ROD
PIN
0706912
0706913
CENTRAL GEAR PIN
CENTRAL GEAR (*)
0706918
SPRING SHIELD
0706919
PRESSURE DEVICE
0706880
GANTY PIN
0706907
ROLLER PRESSURE PIN
0706908
INLET NOZZLE (*)
0706909
SIDE GEAR PIN
0706910
SHAFT FEED ROLLER
0706911
GEAR (*)