ESAB Origo Feed 354 P3 Manual De Instrucciones página 27

NOTA: In order to latch or unlatch, just turn the red handle. There's no need to
remove it.
5.6) Lifting instrucions
To move the feeder around the workplace use the lifting eye for lifting, P/N.: 0401231 according to the
picture below.
6) OPERATION
1) Turn on the power source.
2) Adjust the wire speed, the power source voltage, the anti-stick time and the gas release according to the
wire diameter, thickness and material to be weld.
3) Start the welding and re-adjust the parameters, if needed.
7) MAINTENANCE
7.1) Recommendations
The Wire feeder requires little maintenance in normal environment and operation conditions. It is sufficient
to blow it dry clean using dry compressed air free from oil once a month.
After cleaning the equipment with blow dry air, check that the electric connections and components are
properly fixed. Check for possible faults in the wire isolations or electric cables, including the welding cable
and any others and if any of them is faulty substitute it.
When working with damaged wires or cable or with worn out isolation, the non-isolated parts can become in
27
Origo Feed 354 P3