ESAB Origo Feed 354 P3 Manual De Instrucciones página 26

TABLE 5.1.1
Wyre type
Pressure rollers
Solids, steels
Aluminium alloys
Cored wire
7) Install the inlet nozzle and the intermediate nozzle according to the wire diameter used
(see table 5.2 or 5.2.1 from serial number: A11350002).
TABLE 5.2
Wire diameter (mm)
Inlet nozzle
Intermediate nozzle
TABLE 5.2.1
Wire diameter (mm)
0,8 - 1,6
1,6 - 2,4
0,8 - 1,2 (Aluminium alloys)
5.4) Wire feed pressure
Start by making sure that the wire moves smoothly through the wire guide.Then set the pressure of the wire
feeder's pressure rollers. It is important that the pressure is not too great.
To check that the feed pressure is set correctly, you can feed out the wire against an insolated object, e.g. a
piece of wood.
When you hold the gun approx. 5 mm from the piece of wood (fig. 1) the feed rollers should slip.
If you hold the gun approx. 50 mm from the piece of wood, the wire should be fed out and bend (fig. 2).
5.5) Installing the wire in the Brake Hub
Adjusting the braking torque:
¡
Turn the red handle to the locked position.
¡
Insert a screwdriver into the springs in the hub.
¡
Turn the springs clockwise to reduce the braking torque.
¡
Turn the springs counterclockwise to increase the braking torque.
Note: Turn both springs through the same amount.
26
Origo Feed 354 P3
Diameter (mm)
--
0,80 - 1,00
1,00 - 1,20
1,20 - 1,60
1,00 - 1,20
1,20 - 1,60
1,60 - 2,40
0,6 - 2,4
Valid for the equipment before the
0706908
serial number A11350002
0706914
Inlet nozzle
Intermediate nozzle
0900988
0725692
0725691
Fig. 1
P/N
0725674
0706964
0706965
0725696
0725698
0706968
0706969
Note:
0725685
Valid for the equipment after the
serial number A11350002
0705687
Fig. 2
Note:
Valid for
equipment after
the serial number
A11350002
Note: