Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Flames inside oven or smoking from
oven vent.
Oven control panel beeps and
displays any F code error.
Surface burners do not ignite.
Surface burner flame uneven or only
part way around burner cap.
Surface burner flame is too high.
Surface burner flame is orange.
•
Excessive spillovers in oven. For example, this will happen for pie spillovers or large
amounts of grease left on the oven bottom. Wipe up excessive spillovers before starting
oven. If flames or excessive smoke are present, follow the
Oven Controls chapter on
•
Oven control has detected a fault or error condition. Press STOP to clear the error code.
Try Bake or Broil function. If the F code error repeats, remove power from appliance, wait
5 minutes, and then repower appliance and set clock with the correct time of day. Try
Bake or Broil function again. If the fault recurs, press STOP to clear and call 1-800-4-MY-
HOME® for assistance (See back cover).
•
Surface control knob was not completely turned to LITE. Push in and turn the surface
control knob to LITE until burner ignites and then turn control knob to desired flame size.
•
Burner ports are clogged. With the burner OFF, use a small-gauge wire or needle to
burner head slots and ignition ports.
the Care & Cleaning section on
•
Range power cord is disconnected from outlet (electric ignition models only). Be sure
power cord is securely plugged into the power outlet.
•
Electrical power outage. Burners may be lit manually. See
page
14.
•
Burner slots or ports are clogged. With the surface burner OFF, clean ports with a small-
gauge wire or needle. Also, moisture is present after cleaning. Lightly fan the flame and
allow burner to operate until flame is full.
•
Burner caps are not seated properly. Check that all burner caps are level and seated
correctly on burner heads.
Cleaning section on
page 22
•
Surface control knob is set too high. Adjust to lower flame setting. Burner caps are not
seated properly. Check that all surface burner caps are level and seated correctly on
surface burner heads.
Cleaning section on
page 22
•
Incorrect L.P. conversion. Refer to L.P. conversion kit instructions to correct.
•
Dust particles in main gas line. Allow the burner to operate a few minutes until flame
turns blue. In coastal areas, a slightly orange flame is unavoidable due to salt content in
air.
•
Incorrect L.P. conversion. Refer to L.P. conversion kit instructions to correct.
page
19.
See"Cleaning the Cooktop and Surface Burners"
page 22
for additional cleaning instructions.
See"Cleaning the Cooktop and Surface Burners"
for additional cleaning instructions.
See"Cleaning the Cooktop and Surface Burners"
for additional cleaning instructions.
27
Before You Call
"Setting Broil"
instructions in
"Setting Surface Burners"
on
in the Care &
in the Care &
in
Capítulos
Tabla de contenido
