Procedure Of Control Panel Change - Kenmore 796.8077 Serie Guia De Uso Y Cuidado E Instrucciones De Instalacion

PROCEDURE OF CONTROL PANEL CHANGE

WARNING
• Disconnect power before servicing.
• Replace all parts and panels before operating.
• Be careful of the sharp edge on frame which makes you hurt.
• Failure to follow these instructions can result in death or electrical shock.
Disassemble
1. Push the cap on the right side of control panel.
2. Remove the screw.
3. Slide the control panel to the right about an inch.
Control Panel
Push the housing hook and disassemble the panel.
WARNING
Be careful of dropping the control panel.
Housing
Hook
Remove the plate by lifting it up slightly.
INSTALLATION INSTRUCTIONS
Cap
Frame
Plate
1. Push the cap on the right side of lower cover.
2. Remove the screw.
3. Slide the lower cover to the right about an inch.
Lower, Cover
Assemble
Remove the safety cover.
Safety Cover
Attach the housing of control panel until it clicks into
place.
WARNING
Make sure that the housing is attached correctly.
If not, the dryer may not operate.
18
Cap
Frame
Housing