Tabla de contenido
Idiomas disponibles
Idiomas disponibles
WARNING:
manual, including the Important Safety Instructions, before operating this dryer.
CONTROL PANEL FEATURES
2
1
1
POWER (ON/OFF) BUTTON
Press to turn the dryer ON. Press again to turn
the dryer OFF.
NOTE: Pressing the Power button during a cycle
will cancel that cycle and any load settings will be
lost.
2
CYCLE SELECTOR KNOB
The CYCLE SELECTOR KNOB is used to select the
desired dry cycle by rotating the knob in either
direction until the desired cycle LED is illuminated.
Once the desired cycle has been selected, the
standard presets for that cycle will be shown in the
display. These settings can be adjusted using the
Cycle Modifier or Option buttons anytime before
starting the cycle. (See the Cycle Guide on page 23
for allowable settings. To protect your fabrics, not all
settings are allowed in all cycles.)
3
START/PAUSE BUTTON
Press the START/PAUSE button to begin the cycle.
The display will change, and the dryer will display the
estimated (SENSOR DRY) or set time (MANUAL
DRY) remaining and start tumbling. To pause the cycle
at any time, open the dryer door or press PAUSE. To
resume the cycle where it was stopped, press
START/PAUSE again.
NOTE: If the dryer has been stopped for more than 4
minutes, the dryer will turn off automatically.
HOW TO USE
To reduce the risk of fire, electric shock, or injury to persons, read this entire
3
6
4
OPTION BUTTONS
The option buttons allow you to select additional
cycle options. The controls can be locked or
unlocked by pressing and holding the Control Lock
button for 5 seconds.
MORE TIME and LESS TIME options are not
available with sensor dry cycles.
For detailed information about the individual options,
please see the following pages.
5
CYCLE MODIFIER BUTTONS
Use these buttons to adjust the desired cycle options
for the selected cycle. The lights above the buttons
show the current selection. See page 26 for a
complete description (NOTE: Some settings are not
allowed on some cycles.).
6
TIME AND STATUS DISPLAY
The display shows the estimated time remaining and
the cycle status. The display also monitors the vent
and lint filter status. See page 25 for a complete
description.
21
5
4
Capítulos
Tabla de contenido
Solución de problemas
