Wolf DD30 Manual Del Usuario página 12

IN S TA L L AT I O N
Installation
C ON TR O L MO DU L E
Use the template provided on the following page to mark
1
the holes for the mounting screws. Drill one 1
hole in the center and two
screws.
CAUTION
Verify the scale of the template if not using the installa-
tion guide shipped with the downdraft.
Check the countertop thickness to make sure the
2
threaded studs are long enough to allow the thumbnuts
to fully engage. Thicker countertops may require the
countertop be countersunk from below.
Place the control module on the countertop then secure
3
using the two nuts provided. Once secure, install the
ground wire and nut.
Use the provided cable or a cable designated by the
4
National Electric Code, NFPA/ANSI 70 or local codes.
Connect one end of the control cable to the back side
of the control module and the other to the electrical
connection on the front of downdraft assembly. Ensure
all connections are tight.
WARNING
Do not connect to a telecommunication network.
GROUND
RJ45
CONNECTOR
Downdraft connection
12 | Wolf Customer Care 800.222.7820
9 / "
(40)
16
3 / " holes for the mounting
(10)
8
CONTROL MODULE
RJ45
CONNECTOR
NUT
GROUND
COUNTERTOP
Control module connection
TO P C O VER
Plug the downdraft power cord into a grounded 3-prong
receptacle, then route beneath the appliance and away from
the heat generated by the cooktop. Check the downdraft
operation.
Once operation is verified, raise the downdraft chimney and
install the top trim using the three nuts provided. Verify the
top trim is properly aligned with the side covers. Refer to the
illustration below.
FI LTER S
Install the filters. Refer to the illustration below.
TOP COVER
Top cover installation Filter installation