Battery Pack - Sony Handycam DCR-PJ6 Guía De Operaciónes

When not using your camcorder for a
long time
To keep your camcorder in optimum state for a

long time, turn it on and let it run by recording
and playing back images about once a month.
Use up the battery pack completely before

storing it.
LCD screen
Do not exert excessive pressure on the LCD

screen, as it may cause damage.
If your camcorder is used in a cold place, a

residual image may appear on the LCD screen.
This is not a malfunction.
While using your camcorder, the back of

the LCD screen may heat up. This is not a
malfunction.
To clean the LCD screen
If fingerprints or dust make the LCD screen

dirty, it is recommended that you use a soft
cloth to clean it. When you use the LCD
Cleaning Kit (sold separately), do not apply the
cleaning liquid directly to the LCD screen. Use
cleaning paper moistened with the liquid.
To clean the projector lens (DCR-PJ6)
Wipe the lens gently with a soft cloth such as a

cleaning cloth or glass cleaning cloth.
Stubborn stains may be removed with a soft

cloth such as a cleaning cloth or glass cleaning
cloth lightly dampened with water.
Never use a solvent such as alcohol, benzene or

thinner; acid, alkaline or abrasive detergent; or
a chemical cleaning cloth, as they will damage
the lens surface.
On handling the casing
If the casing is soiled, clean the camcorder body

with a soft cloth lightly moistened with water,
and then wipe the casing with a dry soft cloth.
Avoid the following to avoid damage to the

finish:
Using chemicals such as thinner, benzine,

alcohol, chemical cloths, repellent, insecticide
and sunscreen
US

Handling the camcorder with above

substances on your hands
Leaving the casing in contact with rubber or

vinyl objects for a long period of time
About care and storage of the lens
Wipe the surface of the lens clean with a soft

cloth in the following instances:
When there are fingerprints on the lens

surface
In hot or humid locations

When the lens is exposed to salty air such as

at the seaside
Store in a well-ventilated location subject to

little dirt or dust.
To prevent mold, periodically clean the lens as

described above.
On charging the pre-installed
rechargeable battery
Your camcorder has a pre-installed rechargeable
battery to retain the date, time, and other settings
even when the camcorder is turned off. The pre-
installed rechargeable battery is always charged
while your camcorder is connected to the wall
outlet (wall socket) via the AC Adaptor or while
the battery pack is attached. The rechargeable
battery will be fully discharged in about 3 months
if you do not use your camcorder at all. Use
your camcorder after charging the pre-installed
rechargeable battery. However, even if the pre-
installed rechargeable battery is not charged, the
camcorder operation will not be affected as long
as you are not recording the date.
Procedures
Connect your camcorder to a wall outlet (wall
socket) using the supplied AC Adaptor, and leave
it with the LCD screen closed for more than 24
hours.

Battery pack

When you remove the battery pack or

disconnect the AC Adaptor, close the LCD
screen and make sure that the POWER lamp
(p. 10), the access lamp (p. 10) are turned off.