Stenner ECON FP Serie Manual De Instalación Y Mantenimiento página 34

TUBE REPLACEMENT
D
E
INSTALL NEW TUBE
1. To install new tube, insert one fitting into slot, pull tube around the center of the roller
assembly and insert second fitting into the other slot. Illustration D
2. Align tube housing cover with track and slide over tube until fully closed. Illustration E
3. Plug the pump in.
4. Run the pump to relax the tube. First, press and continue to hold
, hold both buttons for one minute.
PRIME
5. To lock cover in place, press down on the cover while turning the vertical tab 180 degrees
from right to left. Install the Phillips head locking screw (CE models only). Illustration F
6. Take the pump out of standby. First, press and continue to hold
. Run the pump for one minute to verify operation. First, press and continue to
STBY
hold , then press
MODE
7. Put pump in standby. First, press and continue to hold
Reconnect the suction and discharge lines.
8. Prime pump. First, press and continue to hold
9. Place pump in desired operating mode. First, press and continue to hold

press or
programming, slide the cover on and reinstall the screw.
34
Econ FP
F
, hold both buttons for one minute.
PRIME
, release both buttons to select operating mode. After

www.stenner.com
continued
MODE
, then press
MODE
, then press
MODE
, then press
MODE
, then press
STBY
.
PRIME
MODE
.
, then