Control Panel Guide - Stenner ECON FP Serie Manual De Instalación Y Mantenimiento

CONTROL PANEL GUIDE – BUTTONS
The control panel has a backlit LCD display; when operating it will display the operating
modes and the % setting. The pump is factory pre-set at the lowest settings. The keypad is
locked and in standby mode.
%
MODE
To unlock the keypad, simultaneously press and hold
keypad will automatically lock if there is no operation for 60 seconds.
Following are the buttons for programming the modes of operation.
MODE PRIME
To prime the pump or run the pump at full speed, first press & continue to hold
then press .
PRIME
MODE STBY
To place the pump in or out of standby, first press & continue to hold
press . The pump will not respond to incoming signals when in STBY mode.
STBY

or
MODE
To select a mode of operation, first press & continue to hold
to scroll through the selections. The display will show FLOW SWITCH, AUXILIARY (for

12-24 VAC/VDC), or SECONDS.

%
or
After the operational mode is selected, select the percentage setting. First press & continue
to hold , then press
%
10
Econ FP

or until the desired percentage is reached.


www.stenner.com
%
and for 5 seconds. The
MODE
MODE
, then press
MODE
,
MODE
, then

or