Preparing Programing & Installing Your Electronic Smartdoor - Petsafe SmartDoor Guia Del Usuario

Preparing Programing & Installing Your
Electronic SmartDoor
Step 1: Choose a Location for your Door
Household appliances (such as laptop computers, wireless telephones, microwave ovens and televisions)
should be at least 2 feet away from the SmartDoor.
Step 2: Install the 4 D-Cell Batteries
1. With a Phillips screwdriver, remove the two Battery Box
Cover screws.
2. Remove the Battery Box Cover.
3. Refer to the inside of the Battery Box Cover for the proper
orientation of the four D-Cell batteries.
4. Replace the Battery Box Cover and re-install the 2 Battery
Box Cover screws.
5. When the batteries are placed in the Electronic SmartDoor
the red LED will illuminate for 2 seconds and the fl ap will
move into the locked position. If the fl ap is already in the
locked position nothing will happen. Note: The door must
be in the vertical position for the fl ap to center properly and
operate correctly.
Step 3: Install the Range Knob
Fit the Range Knob over the Range Knob shaft (located
above control buttons) and press it fi rmly into place. Note:
The blade in the provided Range Knob must align with the
slot in the Range Knob shaft.
Step 4: Install the PetSafe
1. Place the PetSafe RFA-67 battery into the bottom of the
SmartKey.
2. Using a coin, rotate one-quarter turn clockwise to secure the
PetSafe RFA-67 battery.
Note: The SmartKey has a red LED inside the housing. Should
the LED begin to fl ash, the PetSafe RFA-67 battery is getting
low on charge and should be replaced as soon as possible. In more current SmartKeys, the LED light will
illuminate for 2 seconds when the battery is installed.
RFA-67 Battery in the SmartKey
®
www.petsafe.net
™
5