Installing Your Pet Door; Determine Pet Door Location; Prepare Door - Petsafe PPA00-10958 Manual De Instalación

Installing Your Pet Door

NOTE: If painting the pet door, it is recommended to paint it prior to the pet door being installed.
For best results, use a primer for plastics before applying your paint.
Step 1

Determine Pet Door Location

1A. Measure and mark your pet's shoulder height on the door.
1B. Determine location for the pet door. Draw a vertical center line
through the shoulder height line using a level.
NOTE: If homeowner's door or other application is not level, the
pet door must be marked level to swing properly.
Step 2

Prepare Door

2A. Remove door from hinges.
2B. Place on a raised level surface such as saw horses.
Helpful Tip: Clamp or weigh down the door to prevent it
from moving.
NOTE: The Pet Door can be installed with the door hanging
based on your skill level.
2C. Cut out the correct template size. Match the marked lines on
the door with the shoulder and center lines on the template.
Tape the template in place and carefully trace template. Make
sure to trace underneath tape and connect the corners. Now,
remove the template and any excess tape from the door.
When applying template there should be
a minimum of 3" between the bottom and
sides of the door and the outer edge of the
template to maintain the structural integrity
of the door.
www.petsafe.net
1A
1B
2A
2C
2B
5