Tabla de contenido
Idiomas disponibles
Idiomas disponibles
If the direction you have just programmed is not correct, it is possible to delete the programmed data as described in table "A3", and repeat
the sequence detailed in table "A2".
Table "A3"
Deleting the direction of movement
Press and hold down button ■ on a pre-memorized transmitter (for approx. 5 seconds)
1.
until you hear a beep, release button ■
Press and hold down buttons ▲ and ▼, (for approx. 5 more seconds)
2.
release buttons ▲ and ▼, when you hear the first of 5 beeps, signalling that the
3.
programmed direction of movement has been deleted.
Note: all the remote controls memorized in the motor will no longer command any movement; a new programming procedure must there-
fore be carried out (table "A2")
When one or more transmitters have already been memorised, others may be enabled as detailed in table A4:
Table "A4"
Memorizing other transmitters
Press and hold down button ■ on the new transmitter until you hear a beep
1.
(after about 5 seconds); then release button ■
Press button ■ of a previously enabled transmitter slowly 3 times button ■
2.
Press button ■ on the new transmitter again. Release button ■ when you hear the first
3.
of 3 beeps, signalling that memorization has been carried out.
Note: If the memory is full (30 transmitters), 6 beeps will indicate that the transmitter cannot be memorized.
If you need to delete all programming, carry out the procedure in table A5.
The memory can be deleted:
• with a non-memorised transmitter starting from point A.
• with a previously memorised transmitter starting the procedure from point N. 1
The following can be deleted:
• only the transmitter codes, finishing at point N. 4
• all (transmitters, manoeuvre direction, TTBUS address...), completing the procedure up to point 5.
Table "A5"
Memory deletion
➨
A.
Switch the motor off, activate the Step-by-Step input (connect the White wire with the
Black/White one) and keep it active until the end of the procedure
B.
Connect the motor to the mains power supply and wait for the initial beeps
➨
Press and hold down button ■ on a pre-memorized transmitter (for approx. 5 seconds) until
1.
you hear a beep, then release button ■
Hold down the ▲ button on the transmitter until you hear 3 beeps;
2.
Release the ▲ button exactly during the third beep.
Hold down button ■ on the transmitter until you hear 3 beeps;
3.
Release button ■ exactly during the third beep.
➨
Hold down the ▼, button on the transmitter until you hear 3 beeps;
4.
Release the ▼, button exactly during the third beep.
5.
To cancel everything:
Push buttons ▲ and ▼, within 2 seconds,
Release button ▲ and ▼, on the first of the 5 beeps that confirm the cancellation.
6.
Example
5s
5s
Example
New
5s
Old
x3
New
Example
PP
1-3
5s
5
GB
Tabla de contenido
