Maintenance; How To Replace Initial Filters - HYDROLAB HLP Serie Instrucciones De Uso

7. MAINTENANCE

Maintenance procedures consist of replacing the filter cartridges.
These are:
• pre-filters: 5 μm, A2 module (sediment-carbon-softening)
• ion exchange module
• microfiltration capsule 0.45/0.2 μm
• RO module
• UV lamp radiator.
Disposable materials for particular models are listed on page 71.
7.1 Pre-filters replacement
Pre-filters are: pre-filter 5 μm, A2 module. The frequency of replacement procedures depends on the
amount and quality of feed water. Due to hygenic reasons, the replacement should take place at least once
every 6 months. This procedure may be performed by the user. The system displays a notification „REPLACE
MODULE A" and triggers a sound alarm when the module needs to be replaced.
Step 1
Turn off the device and close the feed water valve.
Step 2
5 μm pre-filter cartridge replacement.
• Twist off the filter housing using a hand or a key.
• Inside the housing there is a rubber gasket - don't lose it.
• Take off the cartridge and put in a new one
• Twist in the housing with a new cartridge until a slight resistance,
and then until the end.
ATTENTION:
63