Feed Water Parameters; Power Supply Parameters - HYDROLAB HLP Serie Instrucciones De Uso

1.2 Feed water parameters

Devices are intended to purify tap or pre-cleaned water.
Pressure - from 4.0 bar (minimum) to 6.0 bar (maximum). A reduction may be used if necessary.
If the pressure is too low, it is recommended to use a pressure pump.
Temperature - the temperature in the room should be between 5°C and 40°C. The feed water
temperature should be between 4°C do 40°C.
Salinity (TDS) - should not exceed 1200 mg/dm
Humidity - the humidity in the room should not exceed przekraczać 80%.
Hardness - should not exceed 250 mg CaCO
Fe - should not exceed 0,2 mg/dm
If any of these parameter requirements is not satisfied, it is recommended

1.3 Power supply parameters

Before connecting the device please make sure, that the voltage specifie on the device conforms with the
voltage of your electrical grid.
• Voltage: 220-240V
• Frequency: 50Hz
3 .
/dm 3 .
3
3 .
to extend the pre-filtration. Please contact our support.
47