EGO POWER+ LM2130SP Manual Del Operador página 47

◾
When mounting the drive gear, the
surface of the gear stating "OUT"
should face toward the outside
(Fig. 33d).
5. Mount the wave washer and the
new wheel on the wheel axle. Note
that the round recess must face
outward.
6. Lock the wheel with the bolt by
tightening the bolt clockwise.
7. Mount the dust cover onto the wheel and press it in place.
REPLACING THE TRAILING SHIELD
WARNING:
mower.
WARNING:
working. Never operate the mower with damaged safety devices. Failure to do so can
result in personal injury. The trailing shield is subject to wear and damage, which could
expose moving parts or allow objects to be thrown. For safety protection, frequently
check the trailing shield and replace it immediately with only the identical replacement
part, listed in this manual.
1. Remove the battery.
2. Turn the mower on its side with
the upper surface against the
wall.
3. Loosen and remove the three
locking screws for the trailing
shield; remove the worn trailing
shield (Fig. 34).
4. Replace with a new trailing
shield and attach it with the three
locking screws.
56-VOLT LITHIUM-ION CORDLESS LAWN MOWER — LM2130SP/LM2130SP-FC/LM2130/LM2130-FC
Always remove the battery pack when servicing or transporting the
Never operate the mower unless the trailing shield is in place and
33d
34
Trailing shield
Locking screw
47