EGO POWER+ LM2130SP Manual Del Operador página 41

9. Place a metal rod (e.g., a 3.5" long
screw bit) with diameter less than
1/4 inch (6.35mm) into the holes in
the fan to act as a stabilizer. Place
another metal rod (e.g., a 3.5" long
screw bit) with diameter less than
5/16" (8mm) into the fixing hole to
act as another stabilizer (Fig. 28).
10. Use a 9/16" (14mm) torque wrench
(not included) to tighten the outer
bolt clockwise. The recommended torque for the outer bolt is 36-43 ft-lb
(50-60Nm).
INSTALLING THE EDGE PREMIUM
TRI CUT LOWER BLADE
If you want to get better mulching and
bagging performance, please replace the
lower blade with the edge premium TRI
cut lower blade as the following steps:
1. Wearing protective gloves.
2. Mount the fan onto the motor shaft
with the fan blade towards the deck
(Fig. 25).
3. Replace the lower blade with the edge premium TRI cut lower blade.
4. Assemble the upper blade and the edge premium TRI cut lower blade following
the direction showed on the Fig.29; fix the two nuts clockwise instead of
tightening them and allow some movements between the two blades (Fig.29).
5. Install the blade set following the step 4 to step 10 showed in the "INSTALLING
THE BLADE".
56-VOLT LITHIUM-ION CORDLESS LAWN MOWER — LM2130SP/LM2130SP-FC/LM2130/LM2130-FC
28
"THIS SIDE
29
FACING DECK"
towards outside
Edge Premium Tri
Cut Lower Blade
(Bent Blade)
Stablilzer 1
Stablilzer 2
"THIS SIDE
FACING GRASS"
towards outside
Upper Blade
(Straight Blade)
41