EGO POWER+ LM2130SP Manual Del Operador página 40

INSTALLING THE BLADE
NOTICE:
To re-install or replace the
blade, be sure to replace the parts in the
exact order in which they were removed
(Fig. 23).
1. Wearing protective gloves.
2. Mount the fan onto the motor shaft
with the fan blade towards the deck
(Fig. 25).
3. When placing the bolt into the hole
in the blade with no clearance
between them, please note that
the diamond protrusion on the bolt
should be aligned with the rhombic
hole on the blade (Fig.26).
4. Assemble the two blades following
the direction showed on the Fig.27;
fix the two nuts clockwise instead
of tightening them and allow some
movements between the two blades
(Fig.27).
5. Position the blade set on the shaft
with the surface stating "THIS SIDE
FACING GRASS" facing toward the
outside (Fig. 28).
6. Use a 43/64" (17mm) torque
wrench to tighten the two nuts. The
recommended torque is 22 ft-lb
(30Nm).
7. Align the outer flange with the shaft and assemble it into place.
8. Mount the outer bolt onto the shaft and turn it clockwise by hand to pre-tighten it.
40
56-VOLT LITHIUM-ION CORDLESS LAWN MOWER — LM2130SP/LM2130SP-FC/LM2130/LM2130-FC
25
26
"THIS SIDE
27
FACING DECK"
towards outside
Lower Blade
(Bent Blade)
Fan Blade
Fan
"THIS SIDE
FACING GRASS"
towards outside
Upper Blade
(Straight Blade)