Operation; Arrangement And Function Of The Operating Elements; Plate Dispenser Adjustment - Hupfer TE-2/V19-26 Manual De Instrucciones

Operation

Arrangement and Function of the Operating Elements

5 Operation
5.1 Arrangement and Function of the Operating Elements
The operating elements are located on the front of the housing of the heated plate dispensers.
Figure 14
The desired temperature can be set on the thermostat. A continuous adjustment is possible within the 4
power ranges. The On / Off switch of the appliance is arranged next to it. An indicator light integrated into the
switch shows, whether the appliance is ready to be operated.
5.2

Plate Dispenser Adjustment

WARNING
The adjustments should only be carried out on the appliances which are switched off, disconnected from the
power supply and cooled down (room temperature).
Before work starts, it is always necessary to check whether the plate dispenser to be operated is correctly
set for the crockery to be used.
The following functions are to be checked separately:

The vertical guide of the plates, in order to prevent any risk of injury to the operating staff if the crock-
ery guides are set too far apart or too close together.

The dispensing height, so that the staff cannot suffer injury or become trapped and no breakage of
crockery can occur.
Basically, the appliance must be adjusted if at least one of the following crockery parameters alters:

Diameter

Height

Stack height

Weight.
4330000_A3 TE-2/V19-26, 27-33 | TE-2/VK19-26 | TEH-1/V19-26, 27-33 | TEH-2/V19-26, 27-33 | TEUH-1/VS19-26 | TEUH-2/VS19-26, 27-33 | TEUH-2/VC19-26
Operating elements
Risk of hot surfaces
The internal surfaces of the heated appliances and the base plates can be-
come hot during operation and only cool down slowly in the air.
To adjust the guide basket, allow the appliance to cool down sufficiently with
the cover removed.
EBR/V19-26, 27-33 | EBRH/V19-26, 27-33 | EBRH-2/V19-26
Chapter 5
Page 27
Plate dispenser