Idiomas disponibles
Idiomas disponibles
Troubleshooting (continued)
Burner(s) will not
light
using ignitor.
(See Electronic
ignition
Troubleshooting
also)
Burner(s) will not
match
light.
Sudden drop in gas
flow or low flame.
Flames blow
out.
Flare-up.
ELECTRONIC
iGNiTiON:
" No spark, no ignition
noise.
" No spark, some ignition
noise.
" Sparks, but not at electrode
or at full
strength.
" See "GAS
iSSUES:" on previous
page.
" Match
will not reach.
" improper
method
of match-lighting.
" Out of gas.
" Excess flow
valve tripped.
" Vapor
lock at coupling
nut/LP
cylinder
con nection.
" High or gusting
winds.
" Low on LP gas.
" Excess flow
valve tripped.
" Grease
buildup.
" Excessive fat in meat.
" Excessive cooking
temperature.
" Grease
trapped
by food
buildup
around
burner
system.
" Burner and/or
burner tubes are
blocked.
" Some dealers
have older
fill nozzles
with worn threads.
" Grease
buildup
or food
particles
in
end(s) of carryover
tube(s).
" See Section
I of Electronic
ignition
System.
" See Section
II of Electronic
ignition
System.
" See Section
III of Electronic
Ignition
System.
" Use long=stem
match
(fireplace
match).
" See "Match=Lighting"
section
of Use and Care.
" Check for gas in LP cylinder.
" Turn off knobs, wait 30 seconds and light grill, if flames
are still
low, turn off knobs and LP cylinder
valve.
Disconnect
regulator.
Reconnect
regulator
and leak=test. Turn on LP cylinder
valve,
wait 30 seconds and then light grill.
" Turn off knobs and LP cylinder
valve.
Disconnect
coupling
nut
from cylinder.
Reconnect
and retry.
" Turn front of grill to face wind
or increase
flame
height.
" Refill LP cylinder.
" Refer to "Sudden
drop
in gas flow"
above.
" Clean
burners and inside of grill/firebox.
" Trim fat from meat
before
grilling.
" Adjust
(lower)
temperature
accordingly.
Persistent
grease fire.
" Turn knobs to OFF. Turn gas off at LP cylinder.
Leave lid in
position
and let fire burn out. After grill cools, remove
and clean
all parts.
Flashback...
" Turn knobs to OFF. Clean
burner
and!or
burner
tubes. See
(fire in burner tube(s)),
burner
cleaning
section
of Use and Care.
Unable
to fill LP
" The worn nozzles don't
have enough
"bite"
to engage
the valve.
cylinder.
Try a second
LP dealer.
One burner
does not
" Clean carry-over
tube(s) with wire brush.
light from other
burner(s).
464323313
° 33
