Kenmore 415.23666310 Manual De Uso Y Cuidado página 11

Ocultar thumbs Ver también para 415.23666310:
Idiomas disponibles

Idiomas disponibles

For Safe Use of Your Grill and to Avoid Serious
Injury:
• Do not let children
operate
or play near grill.
• Keep grill area clear and free from materials that burn
• Do not block holes in sides or back of grill.
Check burner flames regularly.
Use grill only in well-ventilated
space. NEVER use in
enclosed space such as carport, garage, porch,
covered patio, or under an overhead structure of any
kind.
Do not use charcoal or ceramic briquets in a gas grill.
(Unless briquets are supplied with your grill.)
. Do not cover grates with aluminum
foil or any othe_
material.
This will block burner ventilation
and creat_
a potentially
dangerous
condition
resulting in
property
damage
and/or
personal injury.
' Use grill at least 3 ft. from any wall or surface.
Maintain 10 ft. clearance to objects that can catch fire
or sources of ignition such as pilot lights on water
heaters, live electrical appliances, etc.
* Apartment
Dwellers:
Check with management
to learn the requirements
and fire codes for using an LP gas grill in your
apartment
complex.
If allowed,
use outside on the
ground floor with a three (3) foot clearance
from
walls or rails. Do not use on or under balconies.
* NEVER attempt
to light burner with lid closed. A
buildup
of non-ignited gas inside a dosed
grill is
hazardous.
* Never operate grill with LP cylinder out of correct
position specified
in assembly instructions.
* Always close LP cylinder
valve and remove
coupling
nut before moving LP cylinder from
specified
operation position.
Safety
Tips
A
Before opening LP cylinder
valve, check the coupling
nut for
tightness.
A When
grill is not in use, turn off all control
knobs and LP
cylinder
valve.
A
Never move grill while in operation
or still hot.
A
Use long-handled
barbecue
utensils and oven mitts to avoid
burns and splatters.
A Maximum
load far sideburner
and side shelf is 10 Ibs.
A The grease tray must be inserted
into grill and emptied
after
each use. Do not remove grease tray until grill has
completely
cooled.
A Clean grill often, preferably
after each cookout.
If a bristle
brush is used to clean any of the grill cooking
surfaces,
ensure no loose bristles remain on cooking
surfaces prior to
grilling.
It is not recommended
to clean cooking
surfaces
while grill is hot.
A
If you notice grease or other hot material
dripping
from grill
onto valve, hose or regulator,
turn off gas supply at once.
Determine
the cause, correct
it, then clean and inspect valve,
hose and regulator
before continuing.
Perform
a leak test.
A
Keep ventilation
openings
in cylinder
enclosure (grill cart) free
and clear of debris.
A
Do not store objects
or materials
inside the grill cart
enclosure that would
block the flow of combustion
air to the
underside
of either the control panel
or the firebox
bowl.
A The regulator
may make a humming
or whistling
noise during
operation.
This will not affect
safety or use of grill.
A
If you have a grill problem
see the "Troubleshooting
Section".
A
If the regulator
frosts, turn off grill and LP cylinder
valve
immediately.
This indicates a problem
with the cylinder
and it
should not be used on any product.
Return to supplier!
c u,,o.
'
Putting out grease fires by closing the lid is not
possible. Grills are well ventilated for safety
reasons.
'
Do not use water on a grease fire. Personal injury
may result If a grease fire develops, turn knobs
and LP cylinder off.
'
Do not leave grill unattended
while preheating
or
burning off food residue on HIGH. If grill has not
been regularly cleaned,
a grease fire can occur
that may damage the product.
Follow instructions
on General Grill Cleaning and Cleaning The Burner
Assembly to prevent grease fires.
Ignitor
Lighting
the Grill
Do not leon over grill while lighting.
1. Turn OFF gas burner control valves.
2. Turn ON gas at LP cylinder.
3. Open lid during lighting.
4. To ignite,
push and turn the iGNITION
BURNER knob to HI.
5. Push and hold ELECTRONIC
iGNITION
button until the
iGNITION
BURNER lights.
6. If ignition
does NOT occur in 5 seconds, turn the burner
controls OFF, wait 5 minutes and repeat the lighting
procedure.
Z To ignite remaining
burners, turn each burner knob in
sequence to the Hi position, starting
with the burner closest
to the iGNITION
BURNER.
464323313
° 11
loading