I3 Daily Activation Of Machine; I3.1 Standard Filtering And Extraction Phase; I3.2 High Filtering And Extraction Phase; I4 Machine Cleaning - Electrolux ODOURLESS Manual De Istrucciones Para El Uso

I3 Daily activation of machine
• When properly powered, the machine it is always on
standby and is activated whenever the oven is turned on.
I3.1 Standard filtering and extraction phase
• Press button "B" to activate the standard oven fume,
steam and odour filtering function.
I3.2 High filtering and extraction phase
• Press button "C" to activate the oven fume, steam and
odour high filtering function in case of intensive cooking.
In this case the hood will not increase the extraction
speed but only the capacity to eliminate odours.
I4 Machine cleaning
Cleaning must be carried out after every day of use. Use
hot water, a neutral detergent/cleaner if necessary, and
a soft brush or sponge. If another type of detergent is
used, carefully follow the producer's instructions and
observe the safety rules given in the information sheets
provided with the product or substance.
In order to reduce the environmental impact of pollutant
substances, clean the appliance (externally and
internally where necessary) with products that are more
than 90% biodegradable.
ATTENTION!
Do not clean the machine with jets of
water.
ATTENTION!
Do not use steel wool or similar material
to clean the stainless steel surfaces. Do
not use detergents containing chlorine.
ATTENTION!
Contact with chemical substances (e.g.
detergent, rinse aid, scale remover,
etc.) without taking adequate safety
precautions (e.g. PPE) can involve
exposure to chemical hazards and
possible damage to health. Therefore
always refer to the safety data sheets
and labels on the products used.
I4.1 Daily internal cleaning
At the end of the day's work, proceed as follows:
• Turn the appliance off by turning off the oven. The hood
still remains powered. Before unplugging the machine,
make sure the power On light is not flashing (cooling
of components).
• Remove the power plug from the main panel
to which the equipment is connected.
labyrinth filters "E" (fig. 4) in the hood
• Remove the
Zone A.
• Remove the grease collection trays inside the hood
Zone A immediately behind the labyrinth filters.
ATTENTION!
In this phase there is visual contact with
the hood suction fan, whose protection
grilles
To prevent the risk of shearing fingers
the removal of these guards is strictly
forbidden. The Manufacturer declines
any liability if this prescription is not
respected.
• Labyrinth filters and trays can be placed in a dishwasher
or cleaned with a hot water jet to remove all the grease.
• Clean the inside of the hood using rags soaked in
90% biodegradable detergent, making sure no
liquid comes into contact with the suction fan and
catalytic converter.
• Thoroughly dry the parts and components just cleaned.
• Refit the parts.
I4.2 Exterior cleaning
Clean the stainless steel surfaces with lukewarm soapy
water (do not use detergents containing abrasive
substances, steel wool, brushes or scrapers in common
steel) then rinse with a wet cloth and dry thoroughly.
I5 Long idle periods
Whenever the machine is not going to be used for a
long period of time (e.g. one month), take the following
precautions:
• Remove the power plug from the panel where
the machine is connected;
• Turn off the water supply cocks;
• Clean the inside and outside of the machine as
described in par. "I4.1 Daily internal cleaning" and

"I4.2 Exterior cleaning";

• Spread a film of paraffin oil over all the surfaces;
When using the machine again, follow the instructions
given in par. "G2 Starting".
37
are manually removable.