The "Stay" Command - Petsafe HDT11-13910 Instrucciones De Uso

The "Stay" Command

1. Put a separate, non-metallic collar on your pet's neck ABOVE the
Receiver Collar, and attach a long leash. Note: Be sure the extra collar
does not put pressure on the Contact Points.
2. Visibly identify a designated area where you want your pet to sit by
placing his bed or a large piece of cloth on the ground.
3. After identifying a place, put your pet in that area. Hold your leash in
one hand and the Handheld Remote in the other.
4. Staying within approximately 3 feet, walk around the perimeter of the
designated area. Do not say anything to your pet.
5. If your pet tries to leave that area, press and hold the Tone B Button
while saying "Stay" and if necessary use the leash to guide your pet
onto the designated area.
6. Immediately release the Tone B Button as soon as your pet returns to the area, and praise
him enthusiastically.
7. Once your pet has settled, release him and play calmly.
8. Repeat steps 3 to 7 several times.
9. If your pet stays reliably on receiving the spoken "Stay" command, then training is complete.
Release your pet and praise him. If not, move on to Step 10.
10. Put your pet on his designated area and walk around the perimeter as before.
11. Wait for your pet to try to leave that area. Using the Recognition Level for your pet, press
and hold the Tone B and Stimulation Button while saying "Stay" and if necessary guide your
pet back onto the designated area.
12. Immediately release the button as soon as your pet returns
to the area, and praise him enthusiastically.
13. Once your pet has settled, release him and play calmly.
14. Repeat steps 10 to 13 several times.
15. If your pet stays reliably on receiving the spoken "Stay"
command, he may now be ready to respond without
stimulation. Take a play break and then go back and repeat
from Step 3 with Tone B only.
14 Customer Care Center 1-800-732-2677