Petsafe HDT11-13910 Instrucciones De Uso página 5

Receiver Collar: Receives the radio signal from the Handheld Remote. It is waterproof.
On/Off Button: Momentarily pressing and holding this button turns the Receiver Collar on and off.
Contact Points: The contacts through which the Receiver Collar delivers stimulation.
Receiver Indicator Light: Indicates when the Receiver Collar has been turned on or off and
also serves as a low-battery indicator.
Green LED: Tone A and Tone B Indicator.
Red LED: Indicates when stimulation is being delivered and serves as the low battery indicator.
Charging Jacks: For connecting the charger. Although the Handheld Remote and Receiver
Collar are waterproof without the charger covers, keep the covers in place when not charging to
keep debris out of the openings.
Continuous Stimulation: You control when and how long stimulation is delivered to your
dog through the Receiver Collar's Contact Points. When a Continuous Stimulation Button is
pressed for 8 seconds or more, the Handheld Remote will "time-out." The button will need to
be released and pressed again before additional stimulation can be delivered.
Tone A (Low Tone): Use the Tone A (Side Button) as a marker to reinforce positive behavior.
Again, timing is critical. Praise or treat the dog immediately following Tone A.
Tone B (High Tone): Use Tone B (Upper Button) with a Continuous Stimulation to stop
unwanted behaviors. Timing is critical. Tone B followed by Continuous Stimulation should occur
during or immediately after the unwanted behavior. Once your dog associates the High Tone
with the stimulation, you will only need to use Tone B.
Handheld Remote
Remote
Indicator
Light
Side Button
Upper Button
Antenna
Intensity Dial
Lower Button
Charging Jack
(with cover)
www.petsafe.net
Receiver Collar
Receiver Indicator Light
Charging Jack
(with cover)
On/Off Button
Contact Points
(Top)
(Bottom)
5