One Time / One Temperature Cycles; Two Time / Two Temperature Cycles - Excalibur 3548 Manual

ONE TIME / ONE TEMPERATURE CYCLES

Step 1
Plug unit into a power source. Turn power switch on from back of controller.
Step 2
Default temperature is set to Fahrenheit (F). To select Celsius (C), press the "Start" key and the "Time
Subtract" key simultaneously for two seconds.
Step 3
Set temperature & time. Press temp key once to change by 1° increments or "press and hold"
for rapid change. Press time key once to change by 1 minute increments or "press and hold" briefly for
15 minute increments. Continue to "press and hold" for rapid hour change.
Step 4
Press START to begin
Step 5
Press STOP to end or cancel program.

TWO TIME / TWO TEMPERATURE CYCLES

Step 1
Plug unit into a power source.
Step 2
Default temperature is set to Fahrenheit (F). To select Celsius (C), press the "Start" key and the "Time
Subtract" key simultaneously for two seconds.
Step 3
To select two time, two temp mode, press the "Stop" key
and the "Time Subtract" key simultaneously for two seconds.
Step 4
Set temperature & time. Press temp key once to change
by 1° increments or "press and hold" for rapid change.
Step 5
Press time key once to change by 1 minute increments or "press and hold" briefly for 15 minute
increments. Continue to "press and hold" for rapid hour change.
Step 6
Press the "Stop" key and the "Time Subtract" key simultaneously for two seconds.
Step 7
Set temperature & time. Press temp key once to change by 1° increments or "press and hold"
for rapid change.
Step 8
Press time key once to change by 1 minute increments or "press and hold" briefly for 15 minute
increments. Continue to "press and hold" for rapid hour change.
Step 9
Press START to begin
Step 10
Press STOP to end or cancel program.
Operating Instructions
Operating Instructions
3