Washer Dimensions; Location Requirements - KENMORE ELITE HE 3 Plus 110.4580 Serie Manual Del Propietário

Selecting the proper location for your washer improves
performance and minimizes noise and possible washer "walk."
Your washer can be installed under a custom counter, or in a
basement, laundry room, closet, or recessed area. See "Drain
System."
Companion appliance location requirements should also be
considered. Proper installation is your responsibility.
You will need
• A water heater set to deliver 120°F (49°C) water to the
washer.
• A grounded electrical outlet located within 6 ft (1.8 m) of
where the power cord is attached to the back of the washer.
See "Electrical Requirements."
• Hot and cold water faucets located within 4 ft (1.2 m) of the
hot and cold water fill valves, and water pressure of
20-100 psi (137.9-689.6 kPa).
A level floor with a maximum slope of 1" (2.5 cm) under
entire washer. Installing the washer on soft floor surfaces,
such as carpets or surfaces with foam backing, is not
recommended.
• A sturdy and solid floor to support the washer with a total
weight (water and load) of 400 Ibs (180 kg).
Do not operate your washer in temperatures below 32°F (0°C).
Some water can remain in the washer and can cause damage in
low temperatures.
Installation clearances
• The location must be large enough to allow the washer door
to be fully opened.
• Additional spacing should be considered for ease of
installation and servicing.
• Additional clearances might be required for wall, door, and
floor moldings.
• Additional spacing of 1" (2.5 cm) on all sides of the washer is
recommended to reduce noise transfer.
• Companion appliance spacing should also be considered.
Washer Dimensions
50W'
(128.3crn)
Recommended installation spacing for custom
undercounter installation
The dimensions shown are for the recommended spacing.
Custom undercounter installation - Washer only
39"rain.
(99.0 cm)
4,
(2.5 cm) (68.6 crn) (2.5 crn)
Recommended installation spacing for recessed or
closet installation, with or without a pedestal
The dimensions shown are for the recommended spacing.
Recessed area or closet installation
84"'
(86.4 cm)
_...,, _-
48 in?*-; _-
(310cm 2)
34in,2' =
(150 c rn 2 )
I1" I_- 31_/=" _1 4"1_-
(2.5 cm) (80 cm) (10.2 crn)
A
3"
(7.6cm)
3"
(7.0cm)
A. Side view - closet or confined area
B. Closet door with vents
*Min. top and bottom air openings for closet door.
Recessed or closet installation - Washer on pedestal
1" --_- ,(-_ 27" ---_ _-- 1"
(2.5 cm) (68.6 cm) (2.5 cm)
A
18" min,_
L_ (45.7crn)
I1"I_-31W' _'1 4"1
(2.5 cm) (00 crn) (10.2 crn)
B
A. Recessed area
B. Side view - closet or confined area
31W'
(80.0 o re)