Leveling The Washer - KENMORE ELITE 796.2947 Serie Manual De Uso

LEVELING THE WASHER

The tub of your new washer spins at very high speeds.
To minimize vibration, noise, and unwanted movement,
the floor must be a level, solid surface.
NOTE: Adjust the leveling feet only as far as necessary
to level the washer. Extending the leveling feet more
than necessary can cause the washer
to vibrate.
NOTE: Before installing the washer,
make sure that the floor is clean,
dry and free of dust, dirt, water and
oils so the washer feet cannot slide
easily. Leveling feet that move or
slide on the floor can contribute to
excess vibration and noise due to
poor contact with the floor.
All four leveling feet must rest solidly on the floor.
Attempt to rock the washer from corner to corner to
make sure that all four leveling feet are in firm contact
with the floor.
1. Position the washer in its final location, taking special
care not to pinch, strain, or crush the water and drain
lines. Place a level across the top of the washer.
Raise
2. Adjust the leveling feet. Turn clockwise to raise the
washer or counterclockwise to lower it.
Right
3. To make sure that the washer is properly level, open
the lid and look from above to see if the tub is
centered. If the tub is NOT centered (as shown in the
drawing on the right), readjust the front feet. If you
have a level, check your washer with the level.
• To check if the washer is level from side to side, place
• To check if the washer is level front to back, place a
Lower
Wrong
11
INSTALLATION INSTRUCTIONS
a level on the back edge of the lid.
level at the side of the washer on the edge where the
cabinet side meets the top cover. Do not place the
level on the top or the lid. Using these surfaces will
result in the washer being unlevel.
Lower
side to side
front to back
Raise