Mode If Ft1 Photocell Beam Is Broken While Opening; Mode If Ft1 Photocell Beam Is Broken While Closing; With Gate Closed, Enable Opening With Ft1 Beam Broken; Mode If Ft2 Photocell Beam Is Broken While Opening - Roger H70/200AC Instrucciones Y Advertencias Para El Instalador

50 00

Mode if FT1 photocell beam is broken while opening

00
IGNORE, no action or FT1 not installed
01
STOP, the gate stays where it is until it receives a new command
02
REVERSE IMMEDIATELY, hence the gate closes
03
TEMPORARY STOP, once the beam is clear, the gate will continue opening
04
REVERSE WHEN CLEAR, once the beam is clear, movement is reversed, hence the gate closes
51 02

Mode if FT1 photocell beam is broken while closing

00
IGNORE, no action or FT1 not installed
01
STOP, the gate stays where it is until it receives a new command
02
REVERSE IMMEDIATELY, hence the gate opens
03
TEMPORARY STOP, once the beam is clear, the gate will continue closing
04
REVERSE WHEN CLEAR, once the beam is clear, movement is reversed, hence the gate opens
52 01

With gate closed, enable opening with FT1 beam broken

00
gate not allowed to open
01
gate allowed to open
02
OPEN WHEN BEAM BROKEN
53 03

Mode if FT2 photocell beam is broken while opening

00
IGNORE, no action or FT2 not installed
01
STOP, the gate stays where it is until it receives a new command
02
REVERSE IMMEDIATELY, hence the gate closes
03
TEMPORARY STOP, once the beam is clear, the gate will continue opening
04
REVERSE WHEN CLEAR, once the beam is clear, movement is reversed, hence the gate closes
54 04

Mode if FT2 photocell beam is broken while closing

00
IGNORE, no action or FT2 not installed
01
STOP, the gate stays where it is until it receives a new command
02
REVERSE IMMEDIATELY, hence the gate opens
03
TEMPORARY STOP, once the beam is clear, the gate will continue closing
04
REVERSE WHEN CLEAR, once the beam is clear, movement is reversed, hence the gate opens
55 01

With gate closed, enable opening with FT2 beam broken

00
gate not allowed to open
01
gate allowed to open
02
OPEN WHEN BEAM BROKEN
56 00

With gate fully open, close 6 seconds after photocell beam is broken

00
OFF (no action taken when photocell beam is broken)
01 break in FT1 closes gate
02
break in FT2 closes gate
39