Tabla de contenido
Idiomas disponibles
Idiomas disponibles
CAUTION! IF THE BATTERY REMINDER FINGER IS NOT HELD
DOWN IN THE BATTERY COMPARTMENT BY THE BATTERY,
THE BATTERY DOOR WILL NOT CLOSE, THE AC QUICK CON-
NECTOR WILL NOT ATTACH TO THE ALARM, AND THE
ALARM WILL NOT ATTACH TO THE TRIM RING.
The Model PI2000 Smoke Alarm is powered by a 9V alkaline bat-
tery (lithium batteries may also be used). A fresh battery should
last for one year under normal operating conditions. This alarm
has a low battery monitor circuit which will cause the alarm to
"chirp" approximately every 30 - 40 seconds for a minimum of
seven (7) days when the battery gets low. Replace the battery
when this condition occurs.
USE ONLY THE FOLLOWING 9 VOLT BATTERIES FOR SMOKE
ALARM REPLACEMENT.
Alkaline Type:
Lithium Type:
After installing or changing the battery, reinstall your alarm. Test
your alarm by using the test button and check that the green LED
is on.
NOTE: WEEKLY TESTING IS REQUIRED.
CLEANING YOUR ALARM
YOUR ALARM SHOULD BE CLEANED AT LEAST ONCE A YEAR
To clean your alarm, remove it from the mounting bracket as out-
lined in the beginning of this section. You can clean the interior of
your alarm (sensing chamber) by using compressed air or a vacu-
um cleaner hose and blowing or vacuuming through the openings
around the perimeter of the alarm. The outside of the alarm can
be wiped with a damp cloth. After cleaning, reinstall your alarm
and test your alarm by using the test button and check that the
green LED is on. If cleaning does not restore the alarm to normal
operation the alarm should be replaced.
7. LIMITATIONS OF SMOKE ALARMS
WARNING: PLEASE READ CAREFULLY AND THOROUGHLY
• NFPA 72 states: Life safety from fire in residential occupancies is
based primarily on early notification to occupants of the need to
ENERGIZER 522; DURACELL MN1604, MX1604,
GOLD PEAK 1604A PANASONIC 6AM6, 6AM-6,
6AM-6PI, 6AM6X, and 6LR61(GA)
ULTRALIFE U9VL-J
Tabla de contenido
