Measurement Of Frequency; General Characteristics - Chauvin Arnoux F11N Manual De Funcionamiento

11. FREQUENCY MEASUREMENTS
NB : This function is only available on the F13N.
Warning : under no circumstances may the two-
types of input (voltage and current) be connected at
the same time.
Frequency measurements on the voltage input
 Check that the clamp is not clamped around a cable.
 Set the switch to the Hz function.
 Connect the red lead to the + terminal and the black
one to COM then connect up to the element to be
measured.
 Memorise the measurement, if necessary, by pressing
one of the HOLD keys.
Frequency measurements on the current input
 Check that the leads are disconnected.
 Set the switch to the Hz function.
 Place the clamp around the cable.
 If necessary, record the measurement by pressing one
of the HOLD keys.

12. GENERAL CHARACTERISTICS

12.1 Power supply
 1 standard 9V alkaline battery (type IEC 6LF22 or NEDA
1604).
 Service life : F11N : 180 hours without buzzer.
F13N : 100 hours without buzzer.
 Typical consumption : F11N : 2,5mA without buzzer.
 Low battery indication :
12.2 Buzzer
 Continuous beep for the continuity sound test.
 Typical sound level : 70dB(A) at 10cm.
F13N : 3,5mA without buzzer.
is displayed.
23