Husqvarna P 535HX Manual De Usuario página 50

To do a check of the oil level in the hydraulic
system
1. Remove the service lid. Refer to
service lid on page 45
2. Remove the right side cover. Refer to
right side cover on page 45 .
3. Do a check of the oil level in the sight glass. The oil
level must be near the mark in the lower part of the
sight glass.
4. If the oil level is too low, fill the hydraulic system with
hydraulic oil. Refer to
page 50 .
To fill the hydraulic system
1. Remove the service lid. Refer to
service lid on page 45
2. Remove the right side cover. Refer to
right side cover on page 45 .
3. Remove the side hose (A) from the coupling.
B
A
4. Make sure that the opening in the coupling is closed
or attach a hose to the coupling and hold it up.
5. Open the lid (B).
50
To remove the
To remove the
To fill the hydraulic system on
To remove the
To remove the
6. Use a funnel to fill the hydraulic oil into the opening.
Fill until the level is at the lower edge of the sight
glass.
7. Install the lid, the side hose and the covers in
opposite sequence.
To drain the hydraulic system
1. Remove the service lid. Refer to
service lid on page 45
2. Remove the right side cover. Refer to
right side cover on page 45 .
3. Open the lid for the hydraulic system. Refer to
the hydraulic system on page 50 .
4. Remove the drain plug and drain the hydraulic oil.
5. Install the lid, drain plug and covers in opposite
sequence.
To replace the hydraulic oil filter
1. Drain the hydraulic system. Refer to
hydraulic system on page 50 .
To remove the
To remove the
To fill
To drain the
1591 - 001 - 21.12.2020