Fitting / Replacing An Abrasive Wheel - Stihl TS 460 Cutquik Manual De Instrucciones

Fitting / replacing an
abrasive wheel
1
The engine must be switched off when
fitting or replacing an abrasive wheel –
slide control / stop switch to "0" or c
In order to block the arbor,
:
slide the locking pin (1) through the
bore in the V-belt guard (turn the
arbor a short distance with the
combination wrench if necessary)
until the locking pin engages in one
of the bores behind the guard.
TS 460
: Use the combination wrench to
loosen and unscrew the hexagon
bolt (2).
:
Remove the front thrust washer (3)
from the arbor together with the
abrasive wheel to be replaced.
English / USA
: Fit the abrasive wheel (4).
Note the arrows indicating the
sense of rotation on diamond
abrasive wheels.
:
Fit the front thrust washer (3).
The catches of the front thrust
washer must engage in the arbor
grooves.
:
Fit the hex head screw and tighten
it down firmly with the combination
wrench (or to about 30 Nm if you
use a torque wrench)
:
Draw the locking pin out of the
V-belt guard.
21