Assembling The Bearing And Guard - Stihl TS 460 Cutquik Manual De Instrucciones

English / USA
Assembling the bearing
and guard
: Unscrew the hexagon bolts (1) from
the bearing with guard and remove
the V-belt guard (2)
The bearing with guard can be mounted
on the inboard or outboard side of the
cast arm, depending on requirements.
Assembly on the inboard side is
recommended for freehand cutting on
account of the better balance; outboard
mounting is recommended when the
machine is mounted on a STIHL cut-off
machine cart.
18
Assembly
(Inboard mounting is illustrated in the
diagram)
:
The arrow on the tensioning nut (3)
must point to "0" – otherwise
: turn the tensioning nut approx.
1/4 turn counterclockwise as far as
the stop = "0" with the combination
wrench
: Place the V-belt (4) on the V-belt
pulley (5)
: Line up the threaded bores in the
bearing plate (6) with the slots in the
cast arm (7)
:
Fit the V-belt guard (2)
:
Screw in the hexagon bolts (1) as
far as the stop, but do not tighten
them yet
Continue as described under
"Tensioning the V-belt"
TS 460