Tabla de contenido
Idiomas disponibles
Idiomas disponibles
1.
LAYOUT
1)
On/Off Switch
2)
Chain bar
3)
Rubber tires
4)
Hand wheel
5)
Base plate
6)
Dust extraction connector
7)
Lower blade pulley
8)
Upper blade pulley
9)
Tightening screw
11)
Upper blade guide
12)
Side cover
13)
Cover fastener
14)
Retaining screw for upper blade pulley
15)
Machine table
16)
Dial scale for tilt angle
17)
Table insert
18)
Fixing handles for table
19)
Adjustable handle for blade guide
20)
Fixing handle for blade guide
21)
Legs
22)
Setting screw for upper blade pulley
23)
Parallel stop
24)
Machine frame
25)
Blade
2.
ITEMS SUPPLIED
•
Bandsaw
•
Machine table
•
Push stick
•
Parallel stop
•
Base frame
•
Blade
3.
PROPER USE
The bandsaw is intended for the slitting and
cross-cutting
of
workpieces. Round materials may only be cut
with suitable holding devices.
The machine is to be used only for its
prescribed purpose.
Any other use is deemed to be a case of
misuse.
The
user/operator
manufacturer will be held liable for damage
timber
or
wood-like
and
not
and/or injuries of any kind that result from
such misuse. The machine is to be operated
only with suitable saw blades. To use the
machine properly you must also observe the
safety regulations, the assembly instructions
and the operating instructions to be found in
this manual.
All persons who use and service the machine
have to be acquainted with this manual and
must
be
potential hazard.
It is also imperative to observe the accident
prevention regulations in force in your area.
The same applies for the general rules of
health and safety at work.
HOLZMANN will not be liable for any changes
made to the machine nor for any damage
resulting from such changes.
Even when the machine is used as prescribed
it is still impossible to eliminate certain residual
risk factors. The following hazards may arise in
connection with the machine´s construction
and design:
•
Damage to hearing if ear-muffs are not
used as necessary.
•
Harmful emissions of wood dust when
used in closed rooms.
•
Contact with the blade in the uncovered
cutting zone.
•
Injuries
blade.
•
Injury from catapulted workpieces or
parts of workpieces.
•
Crushed fingers.
•
Kickback.
•
Tilting
inadequate support.
•
Touching the blade.
•
Catapulting of pieces of timber and
workpieces.
4.
IMPORTANT INFORMATION
SAFETY INFORMATION
CAUTION! Whenever you use electric tools it
is imperative to take basic safety precautions
in order to reduce the risk of fire, electric shock
and
personal
precautions include:
•
Keep your work area tidy! An untidy
work area may cause accidents.
the
informed
about
the
(cuts)
when
of
the
workpiece
injury.
Essential
ENGLISH
machine`s
changing
the
due
to
safety
Tabla de contenido
