Using The Machine - Alpina C25 Manual De Instrucciones

HOW TO START - USE - STOP THE ENGINE / USING THE MACHINE
The throttle trigger only works if the lockout (3) is
pressed at the same time.
The movement is transmitted from the engine to the
chain by a centrifugal mass clutch that prevents the
chain from moving when the engine is running at
minimum speed.
WARNING!
the chain moves when the engine is running
idle; in this case, contact your dealer.
The correct running speed will be achieved by
pressing the throttle trigger (1) as far as possible.
IMPORTANT
power for the first 6-8 working hours.

7. USING THE MACHINE

IMPORTANT
correctly used chain-saw may disturb others and
have a serious impact on the environment.
To respect people and the environment:
– Avoid using the machine in environments or at
times of the day when it may disturb others.
– Scrupulously comply with local regulations and
provisions for the disposal of waste materials
after sawing.
– Scrupulously comply with local regulations and
provisions for the disposal of oils, damaged parts
or any elements which have a strong impact on
the environment.
– A certain amount of chain lubricating oil is rele-
ased into the environment when the machine is
running, so only use biodegradable oils made
specifically for this use.
– To avoid the risk of fire, do not leave the machi-
ne with the engine hot on leaves or dry grass.
WARNING!
thing when using the machine. Your dealer
can provide you with all the information on
the most suitable accident-prevention devices
to guarantee your safety.
Do not use the machine if
Avoid using the engine at full
Always remember that an in-
Always wear suitable clo-
STOPPING THE ENGINE (Fig. 10)
To stop the engine:
– Release the throttle trigger (1) and allow the en-
gine to run idle for a few seconds.
– Set the switch (4) to «STOP».
WARNING!
speed to a minimum, it may take a few sec-
onds for the chain to stop.
IMPORTANT
off, pull the starter to flood and stop the engine and
immediately contact the dealer to find the cause of
the problem and request necessary repairs.
Do not grip the handles with constant or ex-
cessive pressure.
• Prolonged use of the chain-saw exposes the
operator to vibrations and may cause "white
finger" syndrome. Wear gloves and keep
your hands warm to reduce this risk. If any
"white finger" symptoms appear, seek med-
ical advice immediately. "White finger"
symptoms include: numbness, loss of feel-
ing, tingling, pricking, pain, loss of strength,
changes in skin colour or condition. These
symptoms normally appear in the fingers,
hands or wrists. The risk increases at low
temperatures.
• Plan your work schedule to spread any high
vibration tool use over a number of days.
WARNING!
to use the machine for felling and delimbing.
WARNING!
dy away from the saw chain when the engine
is running.
WARNING!
bad weather, when visibility is poor or in very
high or low temperatures.
Always check the tree for dead branches
which could fall during the felling operation.
EN
When you have reduced
If the machine does not turn
It takes specific training
Keep all parts of your bo-
Never cut in high wind,
13