Adjustments; Instructions And Warning For Adjustments; Adjusting Gas Control Valve Minimum Setting (Top Burners); Adjusting Gas Valve Minimum Setting (Oven) - Angelo Po 1N1FAGV Manual De Uso

INSTRUCTIONS AND WARNING FOR ADJUSTMENTS

Important
Before making any type of adjustment, activa-
te all the safety devices provided and decide
whether staff at work and those in the vicinity
should be informed.
In particular, turn off the gas supply tap and
prevent access to all devices which might cau-
se unexpected health and safety hazards if
turned on.

ADJUSTING GAS CONTROL VALVE MINIMUM SETTING (TOP BURNERS)

To carry out this operation, proceed as follows.
Turn off the gas supply tap.
1)
Pull off the knob (A).
2)
Undo the screws (C) and remove the control
3)
panel (B).
Remove the injector (D) and replace it with
4)
the one suitable for the type of gas in use (see
table at back of manual).
Fully screw the injector.
5)
After making the setting, seal the screw with
6)
paint.
Replace the control panel (B) and the knob
7)
(A) on completion of the operation.

ADJUSTING GAS VALVE MINIMUM SETTING (OVEN)

To carry out this operation, proceed as follows.
Turn off the gas supply tap.
1)
Pull off the knob (A).
2)
Undo the screws (C) and remove the control
3)
panel (B).
Remove the injector (D) and replace it with
4)
the one suitable for the type of gas in use (see
table at back of manual).
Fully screw the injector.
5)
After making the setting, seal the screw with
6)
paint.
Replace the control panel (B) and the knobs
7)
(A) on completion of the operation.
3319990_inst_rev.2_GB

ADJUSTMENTS

These adjustments are only required if the
type of gas to be connected is diff erent from
that used for testing after the conversion
procedure has been carried out (see page11).
Adjustments must be carried out by authori-
sed, qualifi ed staff , in accordance with the re-
levant legal requirements.
- 13 -
Important
Caution - Warning
C
A
C
B
C
A
C
B
D
GB
D
ENGLISH