WEG CFW500 Guía De Instalación, Configuración Y Operación página 7

Ocultar thumbs Ver también para CFW500:
Tabla de contenido
Idiomas disponibles

Idiomas disponibles

The RS232 plug-in module presents the following
features:
Parameterization, command and monitoring of
the inverter by SuperDrive G2 e WLP application
software (available in CFW500 CD-ROM).
CFW500 firmware programming/atualization by FDT
application software (available in CFW500 CD-ROM).
ATTENTION!
With switches S2.1=ON and S2.2=ON the
inverter stays in the firmware programing
state. This operation must only be executed
under WEG's orientation. Improper use of
this application may damage the equipment.
This module has a connector
use of the CFW500-MMF Flash Memory Module , which
allows data transfer between inverters. For further details
on this accessory, refer to the installation and operation
guide of the CFW500-MMF.
NOTE!
When connecting to the PC, the associated
serial port is automatically determined by
the operating system some seconds after
the connection. The user can easily identify
or change the associated COM port in:
Control Panel → System → Hardware →
Device Manager → COM & LPT Ports.
For further details, refer to the installation
manual available in the CD-ROM.
RS232 Communication Plug-in Module
(figure
A.2) to enable the
CFW500 | 9
Tabla de contenido
loading

Tabla de contenido