Duty Cycle; Features - Urrea SOLM1020-BV Manual De Usuario

10. Always keep hoses away from welding spot.
Examine all hoses and cables for cuts, burns, or
worn areas before each use. If any damaged
areas are found, replace the hoses or cables im-
mediately.
11. Read and understand all instructions and
safety precautions as outlined in the manufac-
turer's manual for the material you will weld.
12. Proper cylinder care. Secure cylinders to a
cart, wall, or post, to prevent them from falling.
All cylinders should be used and stored in an
upright position. Never drop or strike a cylinder.
Do not use cylinders that have been dented. Cyl-
inder caps should be used when moving or stor-
ing cylinders. Empty cylinders should be kept in
specified areas and clearly marked "empty."
13. Never use oil or grease on any inlet connec-
tor, outlet connector, or cylinder valves.
14. Use only supplied Torch on this TIG welder.
Using components from other systems may
cause personal injury and damage components
within.
15. People with pacemakers should consult their
physician(s) before using this product. Electro-
magnetic fields in close proximity to a heart
pacemaker could cause interference to, or fail-
ure of the pacemaker.
16. USE PROPER EXTENSION CORD. Make sure
your extension cord is in good condition. When
using an extension cord, be sure to sue one
heavy enough to carry the current your product
will draw. An undersized cord will cause a drop
in line voltage resulting in loss of power and
overheating. A 50 foot extension cord must be
at least 12 gauges in diameter, and a 100 foot
extension cord must be at least 10 gauges in di-
ameter. If in doubt, use the next heavier gauge.
The smaller the gauge number, the heavier the
cord.

DUTY CYCLE

Duty Cycle is the equipment specifications which
defines the number of minutes within a 10 min-
ute period that a piece of equipment can safely
operate.
This MIG welder has a 35% duty cycle, which
means that it may be used only 3,5 minutes at
200 Amps out of any 10 minute period, and
must be rested the remaining 6,5 minutes.
CAUTION: Failure to observe the duty cycle
limitations of this Welder can easily damage this
equipment, and will void warranty.
18

FEATURES

KNOW YOUR TOOL
Before attempting to use this product, become
familiar with all of its operating features and
safety requirements.
1. Model Selector:
Choosing MIG or MMA Welding according the
work needed.
" " MIG welding: when you chose this weld-
ing mode, please plug the welding plug with
cable to the MIG control socket 10 and plug the
earth cable to socket 8).
" " MMA welding: when you chose this weld-
ing mode, please connect the MMA welding
plug and earth cable plug to socket 8 or 9. They
can be exchanged (1).
2. Working Indicator Light. It will be on during
welding operation.
3. Thermal Overload Indicator Lamp. This light
will come on, and the device will shut down if
the tool becomes overheated. Stop trying to use
the welder while leaving the power switch onto
allow the cooling fan to operate, and the lamp
will turn off automatically when the machine
cools down. Please pay attention to the Rated
Duty Cycle.
4. Manual wire feeding: The welder begins to
feed the wire, when this button is pressed and
the wire won't stop running until this button is
released.
5. When it is MMA Welding, You can adjust the
welding current by turning this knob.
6. It is used for control MIG welding Voltage, so
the welding current can be adjusted.
7. The wire feeding speed can be adjusted by
turning this knob.
8. "-"output connector.
9. It is MMA torch connector.
10. It is MIG torch connector.