Petsafe PIF45 Manual De Adiestramiento Y Funcionamiento página 25

The Receiver Collar is
beeping inside the house.
My pet is receiving a
Static Stimulation in his
metal crate.
The Boundary Zone
seems to fluctuate.
The Receiver Collar
activates in the middle of
the garden.
The Receiver Collar is
beeping but my pet is
not responding to the
Static Stimulation.
My pet reacts strongly to
the Static Stimulation and
has become fearful.
The Transmitter Power
Light is not on.
• It is recommended to remove the Receiver Collar fram your pet when
indoors to avoid activation of the Receiver Collar.
• Make sure the Transmitter is plugged in and set up according to
the directions.
• Ensure the entire house is within the Pet Area. The Transmitter may need to
be moved to adjust the Pet Area to include the entire house.
• If relocating the Transmitter, remove the Receiver Collar from your pet before
removing power from the Transmitter.
• The Receiver Collar activates when it loses the Transmitter signal. The metal
crate may block the Transmitter signal which causes the Receiver Collar
to activate.
• Remove the Receiver Collar from your pet when placing him in his
metal crate.
• This is normal for the electro magnetic field of the Stay + Play Wireless
Fence™. The field may be affected by surrounding "electronic noise," which
can cause it to fluctuate up to 5%.
• Where the Receiver Collar activates is influenced by the speed and
orientation of the Receiver Collar as your pet enters the Boundary Zone.
• The Receiver Collar activates when it loses the Transmitter signal. This
sometimes occurs if a large metal object is between the Receiver Collar
and Transmitter, if the orientation of the Receiver Collar changes near the
Boundary Zone, or if the surrounding "electronic noise" interferes with the
signal. If this continues to occur, consider relocating the Transmitter and
resetting the Pet Area.
• Make sure the Static Stimulation Level is set at 2 or above.
• Test the Receiver Collar with the Test Light.
• If the Test Light flashes, check the fit of the Receiver Collar.
• Trim your pet's fur where the Contact Points touch the neck and/or switch to
the longer Contact Points.
• Increase the Static Stimulation Level.
• Repeat training steps to reinforce training.
• Lower the Static Stimulation Level.
• Make sure you are in control of the situation when your pet receives his first
Static Stimulations (have him on a lead attached to a separate, non-metallic
collar) and lead him into the Pet Area and praise him. If your pet remains
fearful, suspend training and start again the next day. Make sure to end all
training sessions on a positive note with lots of praise and play.
• Make sure the Power Light on the Power Adaptor is on when plugged into a
working standard AC wall outlet.
• If Power Adaptor Light is not on, contact the Customer Care Centre for a
replacement Power Adaptor.
www.petsafe.net 25