Introduction; Warranty Information; Specification; Warnings - RAMSEY WINCH DCG-200 Serie Manual De Operacion, Servicio Y Mantenimiento

RAMSEY ELECTRICAL WINCH MODEL DC-200 SERIES
PLEASE READ THIS MANUAL CAREFULLY.
This manual contains useful ideas in obtaining the most efficient operation from your Ramsey Winch, and safety procedures one needs to
know before operating a Ramsey Winch.

WARRANTY INFORMATION

Ramsey Winches are designed and built to exacting specifications. Great care and skill go into every winch we make. If the need should
arise, warranty procedure is outlined on the back of your self-addressed postage paid warranty card. Please read and fill out the enclosed
warranty card and send it to Ramsey Winch Company. If you have any problems with your winch, please follow instructions for prompt serv-
ice on all warranty claims.
* SPECIFICATIONS: Conforms to SAE J706**
Rated Line Pull
lbs.
1st Layer
Kg.
Total Gear
DC-200 ...........................................................................
Reduction
DC-246 ...........................................................................
DC-200/DC-246 (long drum).....................................................
Weight:
DCY-200/DCY-246 (short drum).................................................
MAXIMUM GEAR BOX OIL TEMPERATURE SHOULD NOT EXCEED................................
LAYER OF CABLE
lbs.
* Rated line pull
per layer
Kg.
Long Drum Cable
Capacity per Layer
Short Drum Cable
Capacity per Layer
FPM
Line Speed
MPM
* These specifications are based on recommended 3/8 inch (9.5 mm) diameter extra improved plow steel (EIPS) wire rope
or equivalent.
** Winch only comforms to SAE J706. For SAE qualifications for mounting angles, if applicable, consult Ramsey
Engineering.
NOTE: The rated line pulls shown are for the winch only. Consult wire rope manufacturer for wire rope
ratings.

WARNINGS

CLUTCH MUST BE TOTALLY ENGAGED BEFORE STARTING THE WINCHING OPERATION.
DO NOT DISENGAGE CLUTCH UNDER LOAD.
DO NOT LEAVE CLUTCH ENGAGED WHEN WINCH IS NOT IN USE.
STAY OUT FROM UNDER AND AWAY FROM RAISED LOADS.
STAND CLEAR OF CABLE WHILE PULLING. DO NOT TRY TO GUIDE CABLE.
DO NOT EXCEED MAXIMUM LINE PULL RATINGS SHOWN IN TABLE.
DO NOT USE WINCH TO LIFT, SUPPORT, OR OTHERWISE TRANSPORT PERSONNEL.
A MINIMUM OF 5 WRAPS OF CABLE AROUND THE DRUM BARREL IS NECESSARY TO HOLD THE LOAD. CABLE
CLAMP IS NOT DESIGNED TO HOLD LOAD.
DISCONNECT THE REMOTE CONTROL SWITCH FROM WINCH WHEN NOT IN USE.
...........................................................................
...........................................................................
1
8,000
3,620
ft. 25
m 7
ft. 15
m 4
15
4
2 3
6,700 5,700
3,030 2,580
60 95
18 28
30 55
9 16
30 55
9 16
3
8,000
3,620
470
360
116 lbs (52.7 Kg)
105 lbs (47.6 Kg.)
250° F (121° C)
4
5,000
2,260
140
42
75
22
75
22