Mounting The Drive Tube; Mounting The Loop Handle - Stihl FSE 60 Manual De Instrucciones

Mounting the Drive Tube

2
3
A
Pull the protective cap off the drive
N
tube.
Push the drive tube (1) into the
N
motor housing (2) as far as the mark
(A), turning the drive tube back and
forth at the same time.
Tighten down the screw (3) in the
N
housing firmly.
FSE 60

Mounting the Loop Handle

Mounting the Loop Handle
1
1
A
4
5
40 mm
(1.57 in)
Fit the loop handle (1) on the drive
N
tube about 12 in (30 cm) (distance
A) from the control handle (2).
Insert the hex nut (3) in the loop
N
handle (1).
Squeeze the ends of the clamp
N
together, fit the screw (4) with
washer (5) from the other side and
tighten down firmly.
A
2
3
Adjusting loop handle to most
comfortable position
Loosen the screw (4).
N
Move the loop handle (1) along the
N
drive tube to the required position –
tighten down the screw (4) firmly.
English
13