Bosch MTS 6517 VCI Manual Original página 27

5.2.3 Configuring the VCI Using VCI Manager
In order to configure a VCI to communicate on your net-
work you must connect the VCI, via USB, to a PC run-
ning VCI Manager software. Use the following steps to
configure your VCI.
1. Double-click the VCI Manager icon on your desktop
to launch the VCI Manager software.
2. In the VCI Manager software VCI Explorer tab, select
the VCI in the Detected VCIs window. Click the Show
Details button to see details about the selected VCI.
3. Click the Connect button to connect to the selected
VCI over USB. The VCI is displayed with a green
check mark on your display indicating that your VCI
Manager software is in control of that VCI. Note: If
your VCI is connected to another networked PC, it
will still be detected by the VCI Manager but will be
displayed with a red symbol indicating that it is not
available.
i
If your VCI is connected via USB to your computer,
the VCI Manager functions on all tabs are available;
if your VCI is not connected via USB, the functions
on the Network Setup and VCI Update tabs are not
available.
Robert Bosch GmbH
5.2.4 Check PC and VCI Software Versions
Typically, the VCI Manager software installed on your
PC and the software installed on the VCI must have
matching versions in order for the VCI to operate prop-
erly. Use the following steps to check your software
versions.
1. Connect the VCI to your computer via USB cable.
2. Double-click the VCI Manager icon on your desktop
to launch the VCI Manager software.
3. On the VCI Explorer tab, select your VCI in the De-
tected VCIs window.
4. Click the Show Details button to see the detail view
of the selected VCI.
5. The VCI Detailed View window shows the PC S/W
Version information for the VCI Manager software
and the VCI firmware Version for the VCI as well as
available interfaces and IP addresses. If both the VCI
Manager software version and the VCI software ver-
sion match, you can use your VCI with this PC.
| MTS 6517 VCI | 27 en
|
1699200092 B 2017-06-20